Product ID:SILICONE ALKYD COPOLYMER ENAMEL, 16293 GRAY
MSDS Date:03/01/1997
FSC:8010
NIIN:00N091612
Status Code:A
MSDS Number: CJMMX

Emergency Phone: 206-244-8844

Info Phone: 800-727-9694

Cage: 6F266

Telephone: 206-244-8844

Cage: 6F266

REFINED SOLVENT NAPHTHA; (MINERAL SPIRITS 350)

CAS: 8032-32-4

RTECS: OI6180000

ACGIH TLV: 1370 MG/M3;300 PPM

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: SKIN: THIS MATERIAL MAY CAUSE
IRRITATION, SENSITIZATION, OR DEFATTING OF SKIN UPON PROLONGED OR
REPEATED CONTACT. INHALATION: EXCESSIVE EXPOSURE TO VAPORS OR SPRAY
MIST CAN RESULT IN HEADACHE, DIZZINESS, NAUSEA AND LOSS OF
CONSCIOUSNESS. SOME REPORTS HAVE ASSOCIATED REPEATED & PROLONGED
OCCUPATIONAL OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN &
NERVOUS SYSTEM DAMAGE. EYES: THIS MATERIAL M AY BE AN EYE IRRITANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE, WHEN USED IN ACCORDANCE WITH
SAFE HANDLING INSTRUCTIONS. (SEE SAFE HANDLING AND USE INFORMATION
SECTION).

First Aid:SKIN: PROMPTLY WASH WITH SOAP AND WATER. REMOVE AND WASH ANY
CONTAMINATED CLOTHING BEFORE REUSE. EYES: FLUSH WITH LARGE
QUANTITIES OF WATER FOR AT LEAST 15 MINUTES AND SEEK MEDICAL
ATTENTION. INGESTIO N: IF INGESTED DO NOT INDUCE VOMITING; KEEP
PERSON WARM AND QUIET AND GET MEDICAL ATTENTION. ASPIRATION OF
MATERIAL INTO LUNGS CAN CAUSE CHEMICAL PNEUMONITIS WHICH CAN BE
FATAL. INHALATION: REMOVE VIC TIM TO FRESH AIR IMMEDIATELY. IF
RESPIRATORY SYMPTOMS DEVELOP, SEEK MEDICAL ATTENTION AT ONCE.

Flash Point Method:TCC
Flash Point:=41.7C, 107.F
Lower Limits:0.7%
Upper Limits:6.0%
Extinguishing Media:FLAMMABILITY CLASSIFICATION: OSHA COMBUSTIBLE:
CLASS: 3. FOAM, CO*2, DRY CHEMICAL, OR WATER FOG.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT . USE ABOVE OR ANY CLASS B EXTINGUISHING AGENT. WATER MAY
BE UNSUITABLE AS EXTING MEDIUM, BUT HELPFUL IN KEEPING ADJACENT
CONTAINERS COOL. E VACUATE AREA OF UNPROTECTED PERS.
WEARPROTECTIVE CLTHG.
Unusual Fire/Explosion Hazard:VAPORS MAY FORM EXPLOSIVE MIXTURE IN AIR
AND MAY BE IGNITED BY SPARKS, PILOT LIGHTS, ETC. CLOSED CONTAINERS
MAY RUPTURE WHEN EXPOSED TO EXTREME HEAT.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE
AREA. ABSORB SPILL WITH AN ABSORBENT MATERIAL SUCH AS SAWDUST,
VERMICULITE OR SAND AND PLACE MATERIAL INTO A CLOSED CONTAINER. IF
LARGE SPILL, DIKE AREA TO PR EVENT THIS MATERIAL FROM ENTERING
WATERSYSTEMS OR SEWERS. WEAR PROTECTIVE EQUIPMENT DURING CLEANUP.

Handling and Storage Precautions:AVOID PROLONGED OR REPEATED INHALATION
OF HEATED VAPORS OR SPRAY MIST. KEEP AWAY FROM HEAT OR OPEN FLAME.
THIS MATERIAL MAY CAUSE SENSITIZATION. DO NOT GET IN EYES, ON SKIN
OR CLOTHING. DO NOT ALLOW C ONTAMINATED CLOTHING TO CONTACT SKIN.
Other Precautions:KEEP OUT OF REACH OF CHILDREN. DO NOT WELD ON FULL OR
EMPTY CONTAINERS. KEEP CONTAINERS CLOSED WHEN NOT IN USE, AND
PROPERLY LABELED.

Respiratory Protection:A NIOSH APPROVED CANISTER-TYPE RESPIRATOR MUST
BE WORN TO PREVENT THE INHALATION OF VAPORS OR SRPAY MIST WHEN THE
TLV OR PEL IS EXCEEDED.
Ventilation:GEN VENT IS REQD DURING NORMAL USE. LOC VENT MAY BE REQD
DURING CERTAIN OPERATIONS TO KEEP EXPOSURE LEVEL BELOW (SUPDAT)
Protective Gloves:CHEMICAL RESISTANT NITRILE, NEOPRENE OR RUBBER GLOVES
REQUIRED.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:EYE WASH & DELUGE SHOWER MEETING ANSI DESIGN
CRITERIA . WEAR PROTECTIVE CLOTHING TO PREVENT SKIN CONTACT.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING.
Supplemental Safety and Health
PHYSICAL DATA: WT/GAL: 10.12 LBS. VOC: 340 GRAMS/LITER (LESS WATER).
WASTE DISP: LOCAL, STATE & FED AGENCIES. GROUND HNDLG EQUIP TO PVNT
SPARKS. FOR FURTHER INFO: CONT STATE/LOCALW ASTE AGENCY OR U.S .
ENVIRON PROT AGENCY'S RCRA HOTLINE (1-800-424-9346 OR
1-202-382-3000). VENT: LIMITED LISTED IN INGRED SEC OF MSDS.

Boiling Pt:>152.8C, 307.F
B.P. Text:307-387F
Vapor Pres:2.6 MMHG @ 20C
Vapor Density:HVR/AIR
Spec Gravity:1.21
VOC Pounds/Gallon:340
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:WHITE LIQUID (OR COLOR OF TINT), MILD ODOR.
Percent Volatiles by Volume:45

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDANTS, ACIDS, BASES AND EPOXY HARDENERS
UNDER UNCONTROLLED CONDITIONS.
Stability Condition to Avoid:HEAT, SPARKS & OPEN FLAME. IF PRODUCT
CONTAINS ALUMINUM, MOISTURE IN CLOSED CONTAINERS WILL GENERATE
HYDROGEN GAS.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION CAN YIELD CARBON
MONOXIDE AND TOXIC VAPORS.

Waste Disposal Methods:WASTE DISP METH: IF DISCARDED, MATL & CNTNRS
SHOULD BE TREATED AS HAZ WASTE BASED ON CHARACT OF IGNITABILITY AS
DEFINED UNDER FEDERAL, RCRA REGS (40 CFR 261). DISP OF MATL OR ITS
CNTNRS REQS COMPLIANC E W/APPLICABLE LBLG, PACKAGING &
RECORDKEEPING STDS. WASTE DISP: DISPOSE I/A/W (SUPDAT)

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

Transport Information:DOT: COMBUSTIBLE. UN NUMBER: 1263.

SARA Title III Information:"PURSUANT TO TITLE III OF THE SUPERFUND
AMENDMENTS AND REAUTHORIZATION ACT OF 1986 (SARA) AND 40 CFR PART
372, THIS PRODUCT CONTAINS OR MAY CONTAIN A TOXIC CHEMICAL IN A
QUANTITY SUBJECT TO THE REPORT ING REQUIREMENTS UNDER SECTION 313".
Federal Regulatory Information:HAZARDOUS MATERIAL: YES.